SlickStick™ Linear Actuators
• Standard travel lengths from 6" to 65"
• Stainless steel lead screws with 0.5" or 1.0" lead
• Ready for NEMA 17 or NEMA 23 motor
• Optional home and travel limit sensors
Where are SlickStick actuator products manufactured?
SlickStick actuators are produced at BWC headquarters near San Francisco, California, USA.
What materials are SlickStick actuators made from?
SlickStick is mostly aluminum in construction and made form 6061-T6 and 6063-T6 grades. The fastener hardware is all stainless steel including the lead screw and support bearings. The lead screw nut and sliding element linear bearings are made of plastic polymers.
Why is the carriage preload adjustment feature a benefit?
The ability to adjust the carriage preload is a benefit to end-users because it enables an application specific "feel" or "tune". The adjustment can be loose for less friction and lower wear rates, but a decrease in accuracy with additional carriage rock. A tighter adjustment will have more friction and higher wear rates, but improved accuracy and reduced carriage rock. Adjustments can be made periodically during the life of the actuator to compensate for wear in the bearing elements.
What fasteners are recommended for mounting SlickStick?
The base of the SlickStick has through hole and counter bore features to accommodate either 8-32 or M4 fasteners. Low head cap screws or button head cap screws in stainless steel are recommended.
How do I replace worn parts, or disassemble my SlickStick?
There is a guide for how to properly disassemble my SlickStick and install the replacement parts that come in the repair kit. Contact BWC application engineers for this documentation.
How can I determine if SlickStick will work for my application?
Contact BWC application engineers for free technical advice on your application.